NorAM 65E Turbo, Руководство оператора

Страница: 60 / 118

1
NORAM 65ET GRADER
2-26
Op
era
tion
2
Bank Slope (Optional)
When the motor grader is equipped with the optional rotating
saddle, the moldboard can be rotated 90° to either side for grading
steep slopes.
To rotate saddle and moldboard to the right:
1. Rotate circle, 1, until moldboard, 2, is perpendicular to grader.
2. Side shift the moldboard fully right. Shift the circle to the right
with the cylinder rod extended approximately 5 inches. Lower
moldboard.
3. Disengage saddle lock pin. Using blade lift levers, extend (lower) right moldboard lift cylinder and retract (raise)
left moldboard lift cylinder. The moldboard will slide along the ground as the saddle, 3, rotates.
NOTE:
Raising the moldboard off the ground several times
during this process will release side pressure on frame.
4. Continue step 3 until lock pin is aligned with last hole in the
saddle. Lock saddle using saddle lock pin.
5. Raise both sides of the moldboard slightly from the ground.
Raise right side of the moldboard, 1, and turn the circle
counterclockwise so the right end of the blade is close to the front
tire. This prevents the left side of the moldboard from dragging.
At the same time, shift the circle to the right to pivot the complete
circle/moldboard assembly upward.
6. Continue operation until moldboard has cleared ground. Use
moldboard height control levers to move moldboard in and out.
The moldboard angle can be changed using circle turn lever until
desired moldboard angle is reached.
NOTE:
When grading a bank, moldboard control can be
manipulated easily by leaning the front wheels toward or away
from the bank.
WARNING:
ALWAYS POSITION MOLDBOARD UNDERNEATH UNIT FOR ROAD TRAVEL OR
TRANSPORT ON A TRAILER.