37
2.
Select the Calibration softkey (A) to view the setup menu.
3.
Select the Boom Calibration tab (B).
4.
Select the Calibration icon (C) next to Tilt Sensor Calibration.
5.
The Boom Tilt Sensor Calibration screen will appear.
Figure 38: Tilt Sensor Calibration Screens
6.
Follow the instructions on the first screen. When finished, select the Cal icon (A) to
proceed to the next screen.
7.
Follow the instructions on the second screen. When finished, select the Cal icon (A) to
proceed to the next screen.
8.
“Calibration Complete” will be displayed. Press the Enter button (B) to return to the Boom
Calibration tab.
11.3
JD Tilt Valve Calibration Instructions
1.
Warm up the hydraulic oil to at least 60°C. The calibration screen it will show the oil
temperature.
2.
Ensure the NORAC system is plugged in and powered up.
3.
Test the JD Autofold. Press and hold the foot switch and main up to fold. Press and hold
the foot switch and main down to unfold.
4.
On the display, press the Calibration button (
Figure 39
).
Содержание UC5 Topcon X30
