Norac UC5 Topcon X30, Руководство по установке, Страница: 33 / 50

30
NOTE: A John Deere disc orifice is found between the John Deere block fitting and
hose end. Be careful to not lose this part when removing the main lift hose
to insert the F05 tee. Position the orifice between the F05 tee fitting and
the John Deere hose, so that the orifice restricts flow of both the John
Deere controls and the NORAC controls.
15. Connect hose H03 to the “S” port of the NORAC block.
16. Insert a 6FORXR-6MORT tee (F05) into the existing load sense connection. Install the
4MOR-6FORX fitting (F10) onto the F05 tee. Connect hose H03 to the F10 fitting.
17. Connect hose H01 between the tees (F13) on the “lower” (“A”) lines.
18. Connect two (2) hoses H01 to the tees (F13) on the “raise” (“B”) lines.
19. Install four (4) 6MB-6MOR fittings (F12) onto the ports on the wing roll cylinder (H20).
20. Install four (4) 6MOR-6FORX90 fittings (F14) onto the F12 fitting on the wing roll cylinder
(H20).
21. Install a 6MOR-6FORX90 fitting (F14) onto the F14 fitting on the cable end of H20.
22. Connect hoses H01 from the “raise” lines to the outer ports on the wing roll cylinder
(H20).
23. Connect hose H01 between the “A” port on the wing roll cylinder (H20) and the “A” port
on the NORAC expansion block.
24. Connect hose H01 between the “B” port on the wing roll cylinder (H20) and the “B” port
on the NORAC expansion block.