12
4.3
W
ING
S
ENSOR
I
NSTALLATION
1.
Assemble the Breakaway Sensor Mounting
Brackets (
B13
) as show in
Figure 4
and
Figure 5
.
Figure 4 – Breakaway Sensor Bracket
Exploded View
Figure 5 – Breakaway Sensor Mounting
Bracket Assembly
To assemble the breakaway sensor bracket:
a)
Assemble the bolt and nut into the
collar.
b)
Grease the bottom edge of the collar
and the angled tube of the base.
c)
Place the collar onto the angled tube of
the mounting base.
d)
Install the spring between the collar and
the upper ring of the base.
e)
Insert tube through assembly and tighten
the collar
2.
Mount the sensor bracket onto the boom.
If possible, mount the sensor
brackets while the booms are in
their folded position to ensure that
they will not interfere with anything
when the boom is folded for
transport.
3.
The sensor mounting brackets can be
installed with the mounting base behind
(
Figure 8
) or in front of the tube (
Figure
6
).
Mounting the sensor bracket to the
break-away section of the boom
may cause the boom to drop
suddenly as a break-away occurs.
This will occur on break-away
sections which lift as they break
away.
For optimal boom tip protection, it
is recommended that the sensor be
mounted within approximately two
feet (60cm) of the boom tip.
4.
Mount the NORAC UC4+ ultrasonic sensor
(
E02
) into the sensor brackets. The sensors
should be oriented forward (ahead) of the
boom (see
Figure 6
and
Figure 8
).
When installing the UC4+ sensors
(E02), start with the smallest serial
number on the left hand side
proceeding to the largest serial
number on the right hand side
(Figure 10).
5.
Sensor cables should run through the
mounting bracket tube and then behind the
Содержание UC4+
