31
Figure 41 – Cable Configurations: C10, C1, C4 and C70
2.
Connect the UC4+ power cable (
C10
) and
sensor trunk cable (
C01
) to the UC4+
Control Panel (
E01
) (see
Figure 41
).
Ensure the UC4+ Control Panel’s
power is OFF for the remaining
installation. (Bottom of switch
pressed IN).
3.
Plug the 3-pin connector on
C10
into the
cab’s power bar.
4.
Route the free ends of
C10
and
C01
along
the side of the cab post and under the floor
mat.
Figure 42 – Hole under Floor Mat
5.
Plug the 2 pin tower on
C10
into the 2 pin
shroud on the roll bias cable (
C70)
.
6.
Plug in the 6-pin Tower on
C10
to the 6-pin
Shroud on the valve extension cable (
C04
).
C04 comes with one connector
(M16) unassembled to allow the
cable to be run through a hole in the
floor under the steering column. To
assemble this connector (M16), refer
to the drawing in Section 5.4. The
pins require a special tool to remove
them if you make an error.
The cables may also be routed
through the rear window of the cab.
7.
Route the free ends of
C01
,
C04
and
C70
to the rear of the sprayer near the sprayer
valve block. Run the cables along the
sprayer frame with the JD harness.
The hole in the floor may be covered
by a plate, or a grommet may be
installed in the hole. They can be
reinstalled after the wiring is
complete. NORAC supplies a
grommet (M13) for the hole if one
does not exist.
Содержание UC4+
