43
These settings will be determined for you automatically during the "Retune
?", "Install ?" and "Initial Power Up" sequences. However, it is possible to
manually check and adjust these settings as described below.
6.6.2.1
Valve DeadZone Test
1.
Follow the guidelines listed in Section 6.1 steps 1 to 7 before
proceeding (check level booms, working RPM etc.).
2.
Make sure you are in manual mode, at the operating screen.
3.
Navigate to the "More ?" item in the Setup menu (see Section 1
for help on getting to this screen). Press AUTO (YES).
4.
Navigate to the boom section you wish to setup, for example
"Right ?" to adjust the right up and/or the right down settings.
Press AUTO (YES).
5.
Press the SETUP switch to access the next menu item, in this
case the right up deadzone (DZ).
6.
While viewing the deadzone, two tests are available. To run the
automatic deadzone test, press and hold AUTO. When the
"Done" message is displayed release the auto switch to view the
new setting.
Note – You do not need to run both the automatic and manual
tests. The tests are entirely independent.
7.
The other test available at this screen is the manual deadzone
test. To run, press and hold MANUAL. The valve will fire at
the indicated setting for exactly one-second. The screen will
show the actual change in height.
8.
The change in height reading is live as long as you hold the
MANUAL switch. Wait until the height reading has settled to a
stable value and record this reading.
9.
Repeat steps 7-9 three times.
10.
Average your three readings. The acceptable average change in
height should be from 0.5 to 1.5 inches (ideal would be 1 inch
exactly). If your average is less, increase the DZ setting with
the + switch and repeat steps 6-9. If your average is more,
decrease the DZ setting with the – switch and repeat steps 6-9.
Содержание UC4 Total Control
Страница 36: ...34 ...
Страница 58: ...NOTES ...