Norac UC4.5, Руководство по установке

Страница: 30 / 45

27
12. Remove the Hardi hoses from the “lower” line (the “A” line) of the cylinder and remove
the restricted straight BSPP fittings. (
Figure 26 )
13. Install the 4FBSPPX 6MJ fittings (F04) onto hoses H02. Install NORAC and Hardi hoses
onto the 4MBSPPT 4FBSPPRX tee (F05).
Figure 26: Restrictor to be Replaced on the Tilt Cylinders
14. At the Hardi main valve block, remove the hydraulic hoses that run from the “raise” line of
the tilt cylinders to the valve block (
Figure 27 ). Remove the fittings from between the
hoses and valve block.
15. Install the restrictor that was removed from the wing tilt cylinder between the hoses and
the valve block.
16. Install the fittings that were removed from the valve block between the cylinders and tee
fittings (F05).
17. Remove the pressure and tank hoses from the Hardi valve block and install the 4MBSPPT
4FBSPPRX tee (F05) between the valve block and hoses. Install the 4FBSPPX 6MJ fittings
(F04) onto hoses H01. Connect hoses H01 to each of the tee fittings and route to the
NORAC valve block. Install the corresponding hose to the pressure and tank port on the
NORAC valve block.
Figure 27: Location of Hoses on Hardi Valve Block
Eagle Boom Force Boom
Eagle Boom Force Boom
Replace this
Restrictor