Nolan N43E, Инструкции по безопасности и эксплуатации

Страница: 15 / 76

15
• REMOVABLE INNER COMFORT PADDING
1 DISASSEMBLY
1.1 Open the chin strap (see specific instructions) and pull the front part of the left
cheek pad to the inside of the helmet and pull out the left fastening chin strap from
the slot on the cheek pad (Fig. 7).
Repeat this step for the right fastening strap and cheek pad.
1.2 Release the roll-neck eyelet from the frame fixed to the outer shell (Fig. 8).
1.3 Release the left rear fastening flap from the support fixed to the inner shell by slight-
ly deforming the shell sealing edge and slightly pulling the comfort padding in the
helmet neck-ring area towards the inside (Fig. 9).
Then repeat the same steps to remove the central flap as well as the right rear flap.
1.4 Hold the left front part of the liner and pull it upwards in order to remove the liner
flap from the support fixed to the inner polystyrene shell (Fig. 10). Repeat the same
steps to remove the central and right front flap.
1.5 Completely remove the liner from the helmet.
2 ASSEMBLY
2.1 Insert the liner correctly into the helmet and fit it well against the base.
2.2 Insert the left front flap into the seat on the support fixed to the polystyrene inner
shell and push it slightly downwards until it is completely locked (Fig. 10). Follow
the same steps for the central and right front flap.
2.3 Insert the rear right, central and left flaps of the liner into the relevant support seats
in the helmet neck-ring area (Fig. 9). To perform this step, act as follows: slightly
deform the shell sealing edge and push the flaps until they are completely hooked
to the support.
2.4 Hook the roll-neck eyelet to the frame fixed to the outer shell (Fig. 8), making sure
that the frame central hole is free.
Note: Check the correct assembly of the liner front area by lifting and lowering the
VPS. These movements should be smooth. If this is not the case, repeat the steps
1.4 and 2.2.
2.5 Insert the left chin strap in the slot of the left cheek pad by pulling towards the inside
of the helmet; then push the padding near the snap fastener on its back so that it
is hooked in the hooking seat of the frame fixed to the shell (Fig. 7).
WARNING!!!
- Remove the padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not
been correctly and completely restored.
- Delicately hand-wash in lukewarm water (max. 30°C) and neutral soap.