Nokia RM-57, Руководство по обслуживанию

Страница: 262 / 391

Appendix A: RF Troubleshooting Nokia Customer Care
Company Confidential
Copyright © 2005 Nokia. All rights reserved
A-44
(triggering needed). Another possibility is to use following settings: RBW = VBW = 1 MHz,
Span 200 kHz and sweep time at least 2.5 seconds.
• Check the level of the TX VCO frequency in T7503 outputs. The level should be about
-30…-35 dBm in both output lines. If the signal level is correct in the input (about -25 dBm)
but output level is not as expected then replace T7503. VCO shield has to be removed before
measurement. Remember to solder the shield back after the phone repairing.
3.1.3.1.2.4 Components near TX VCO ok?
C7571, R7519, R7523, C7573 and C7568 working correctly?
• Check that components are in place and solder joints are ok
• Disconnect the power supply from the phone and check resistors resistance values with an
ohmmeter.
• Use an ohmmeter to check also that capacitors are not short-circuited
3.1.3.1.2.5 Replace Vinku (N7501) or TX VCO (G7502) or both
3.1.3.1.3 Replace TX VCO G7502
3.1.3.2 Is TX VCO signal level in the T7503 output high enough?
• GSM transmitter has to be active before TX VCO’s output level can be measured. Procedure is
explained in section “Transmitter troubleshooting”.
•
Measurements can be done with a spectrum analyser and an RF probe. Spectrum analyser
centre frequency should be set according the used TX channel (see section “Frequency
mappings”).
• Spectrum analyser RBW and VBW = 1 MHz, Span = 0, sweep time 1 ms. Notice that GSM
transmission has pulsed nature and VCO output power should be measured during TX burst
(triggering needed). Another possibility is to use following settings: RBW = VBW = 1 MHz,
Span 200 kHz and sweep time at least 2.5 seconds.
•
Check the level of the VCO frequency in T7503 outputs. The level should be about
-30…-35 dBm in both output lines during GSM TX burst. If the signal level is correct in the
input (about -25 dBm) but output level is not as expected then replace T7503. VCO shield has
to be removed before measurement. Remember to solder the shield back after the phone
repairing.
3.1.3.2.1 TX VCO G7502 output level high enough?
• GSM transmitter has to be active before TX VCO’s output frequency and output level can be
measured. Procedure is explained in section “Transmitter troubleshooting”.
•
Measurements can be done with a spectrum analyser and an RF probe. Spectrum analyser
centre frequency should be set according the used TX channel (see section “Frequency
mappings”).
• Spectrum analyser RBW and VBW = 1 MHz, Span = 0, sweep time 1 ms. Notice that GSM
transmission has pulsed nature and VCO output power should be measured during TX burst