Nokia RM-57, Руководство по обслуживанию

Страница: 261 / 391

Nokia Customer Care Appendix A: RF Troubleshooting
Company Confidential
Copyright © 2005 Nokia. All rights reserved
A-43
3.1.3.1.2 TX VCO control voltage VC ok?
• GSM transmitter has to be active before TX VCO control voltage VC can be measured.
Procedure is explained in section “Transmitter troubleshooting”.
• Measurement can be done with an oscilloscope and a probe.
• Connect the probe to R7519.
•
Typical TX VCO control voltage VC should look somehow similar to figure 6.5.3 “TX VC in GSM
mode (DC offset 1.8V) . DC voltage level should change if TX channel is changed. VC is lower on
lower channels and higher if higher channel numbers are used.
3.1.3.1.2.1 VCP2-voltage ok?
• GSM transmitter has to be active before VCP2 voltage can be measured. Procedure is
explained in section “Transmitter troubleshooting”.
• Measurement can be done with an oscilloscope and a probe.
• Connect the probe to C2221 (or C7550).
• VCP2 voltage should be about 4.75 V.
3.1.3.1.2.1.1 C7550 and C2221 working correctly?
• Check that components are in place and solder joints are ok
• Disconnect the power supply from the phone and use an ohmmeter to find out if the VCP2-
line is short-circuited to the ground. If short-circuit is found replace C7550 and C2221. If this
does not help go to the next steps.
3.1.3.1.2.1.2 Retu ok?
3.1.3.1.2.1.3 Vinku (N7501) ok?
3.1.3.1.2.2 Vinku (N7501) RB_EXT voltage ok?
•
See section "Vinku (N7501) RB_EXT voltage ok?"
3.1.3.1.2.3 Balun T7503 ok?
• GSM transmitter has to be active before TX VCO’s output level can be measured. Procedure is
explained in section “Transmitter troubleshooting”.
• Measurements can be done with a spectrum analyser and an RF probe. Spectrum analyser
centre frequency should be set according the used TX channel (see section “Frequency
mappings”).
• Spectrum analyser RBW and VBW = 1 MHz, Span = 0, sweep time 1 ms. Notice that GSM
transmission has pulsed nature and VCO output power should be measured during TX burst