Nokia RM-57, Руководство по обслуживанию

Страница: 257 / 391

Nokia Customer Care Appendix A: RF Troubleshooting
Company Confidential
Copyright © 2005 Nokia. All rights reserved
A-39
• GSM transmitter has to be active before measurements. Procedure is explained in section
“Transmitter troubleshooting”.
• Set TX power level to the maximum (“0” in GSM1800/GSM1900)
• Measurements can be done with a spectrum analyser and an RF probe. Remember to make
correct frequency settings to the spectrum analyser. Spectrum analyser centre frequency
should be set according the used TX channel (see section “Frequency mappings”).
• Spectrum analyser RBW and VBW = 1 MHz, Span = 0, sweep time 1 ms. Notice that GSM
transmission has pulsed nature and power should be measured during TX burst (triggering
needed). Another possibility is to use following settings: RBW = VBW = 1 MHz, Span 200 kHz
and sweep time at least 2.5 seconds.
• GSM1800 or GSM1900: Connect the probe to R7512 input. The RF level should be roughly -
20…-30 dBm.
3.1.2.2.3.1 Replace balun T7502
3.1.2.2.4 GSM1800/GSM1900: Replace attenuator R7512
3.1.2.3 GSM PA (N7502) transmitting correct RF-power?
•
GSM transmitter has to be active before measurements. Procedure is explained in section
“Transmitter troubleshooting”.
• Set TX power level to the minimum (“19” in GSM850/EGSM900 and “15” in
GSM1800/GSM1900)
• Measurements can be done with a spectrum analyser and an RF probe. Spectrum analyser
centre frequency should be set according the used TX channel (see section “Frequency
mappings”).
• Spectrum analyser RBW and VBW = 1 MHz, Span = 0, sweep time 1 ms. Notice that GSM
transmission has pulsed nature and power should be measured during TX burst (triggering
needed). Another possibility is to use following settings: RBW = VBW = 1 MHz, Span 200 kHz
and sweep time at least 2.5 seconds.
• GSM850/EGSM900: Connect the probe to J7520 (test point). The RF level should be about
-16…-17 dBm.
• GSM1800 or GSM1900: Connect the probe to J7519 (test point). The RF level should be roughly
-29…-30 dBm in both bands.
3.1.2.3.1 GSM PA (N7502) operating voltage ok?
• Measurement can be done with an oscilloscope and a probe.
• Connect the probe to C7593
•
Voltage level should be 3.05 – 5.4 V. Typical value is 4.0 V.