Nokia IP380 - Security Appliance, Руководство по установке прибора

Страница: 30 / 114

2
Installing the Appliance
30 IP350 and IP380 Appliance Installation Guide
The fan unit on the power supply turns on when you press the power switch.
Verify that the fans are running after you press the switch.
Check the power LED on the front panel of the appliance (the Nokia logo) to
ensure that the power supply is operating correctly. The power LED should be
illuminated. For more information about the system status LEDs, see
“Status
LEDs” on page 24.
If the power supply fans are not running, or if the power LED is not
illuminated:
Check the power supply cord to make sure it is properly connected.
Make sure the power supply switch is on.
Make sure the chassis assembly is pushed all the way in from the front of
the platform.
Make sure that power is turned on to the power strip or wall receptacle
you plugged the appliance in to.
If the fans are still not running, or if the power LED does not illuminate,
contact your Nokia service provider as listed in
“Nokia Contact Information”
on page 3 for technical support.
Connecting Network Interfaces
Connect at least one network interface to the network to use as the Voyager
system management interface. This interface is configured during the system
startup procedure, which is described in
Chapter 3, “Performing the Initial
Configuration.”
You can also connect the remaining LAN interface wires at this point,
although you are not required to do so.
To connect Ethernet devices:
Use a straight-through RJ-45 cable to connect to a 10-Mbps or
100-Mbps hub.
Use a crossover RJ-45 cable to connect directly to a host.
For details, see “Ethernet NIC Connectors and Cables” on page 50.
All manuals and user guides at all-guides.com