57
Speed Scrub 350 9016424 (09-2017)
MAINTENANCE
6. Place a block of wood underneath the rear of
the machine to provide additional support.
7. When
fi
nished with maintenance, use
fl
oor jack
to raise machine from jack stand, remove the
block of wood from under the machine, and
lower the machine to the
fl
oor.
8. Reinstall the lower shroud onto the machine.
PUSHING, TOWING, AND
TRANSPORTING THE MACHINE
PUSHING AND TOWING THE MACHINE
FOR SAFETY: When servicing the machine,
do not push or tow the machine without an
operator controlling the machine.
If the machine becomes disabled, it can be pushed
from the front or rear, but it can only be towed from
the front.
The brake must be disabled before towing or
pushing the machine. To disable the brake,
insert the tip of a small screw driver between the
electronic brake lever and the hub. The machine
can move freely when the brake is disabled.
Only push or tow the machine for a very short
distance and do not exceed 3.2 kp/h (2 mph). It
is NOT intended to be pushed or towed for a long
distance or at a high speed.
ATTENTION! Do not push or tow machine for
a long distance or damage may occur to the
propelling system.
Immediately after pushing the machine, remove
the screw driver from between the electronic brake
lever and the hub. NEVER operate the machine
with the brake disabled.
FOR SAFETY: Do not operate machine with
brake disabled.
TRANSPORTING THE MACHINE
When transporting the machine by use of trailer
or truck, carefully follow loading and tie-down
procedure:
1. Drain tanks, raise the scrub head and remove
the squeegee assembly.
2. Carefully load machine in trailer or on truck.
FOR SAFETY: When loading/unloading, use a
ramp that can support the machine weight and
operator. Do not turn on inclines or ramps. Do
not drive on a slippery ramp.
FOR SAFETY: When loading/unloading, Do
not operate the machine on a ramp incline that
exceeds an 18% grade level. Use a winch if
ramp incline exceeds an 18% grade level
3. Once loaded, position the front of the machine
up against the front of the trailer or truck.
Lower the scrub head and turn key off.
4. Place a block behind each wheel.
5. Using tie-down straps, secure the machine
using the four tie-down brackets located on the
machine frame. It may be necessary to install
tie-down brackets to the
fl
oor of your trailer or
truck.
NOTE: When transporting machine in an open
truck or trailer, secure recovery tank lid.
ATTENTION: Do not use control console
area or accessory storage rails for tie-down
locations, damage may occur.
