OPERATION
16
Speed Scrub
t
2601 Cylindrical Brush (12–02)
MACHINE MAINTENANCE
To keep machine in good working condition, simply
follow the daily, weekly and monthly maintenance
procedures.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
WARNING: Disconnect Battery Cables Before
Servicing Machine.
ATTENTION: Contact an Authorized Service
Center for machine repairs. Machine repairs
performed by other than an authorized person will
void your warranty.
DAILY MAINTENANCE
(Every 4 Hours of Operation)
1.
Drain and rinse tanks thoroughly (Figure 32). After
draining tanks, hinge recovery tank until you can
see vacuum intake hole at rear of tank. Remove
any debris in hole if necessary.
FIG. 32
2.
Remove and rinse off the float shut–off screen
located in recovery tank (Figure 33).
FIG. 33
3.
Empty and rinse out debris trough (Figure 34).
FIG. 34
4.
Wipe blades down with a dry cloth and store
squeegee in the up position to prevent squeegee
damage (Figure 35). Check squeegee blades for
damage and wear. Rotate or replace blades when
worn or damaged.
FIG. 35
To replace or rotate the front squeegee blade,
unthread the six thumbscrews and remove
retainer band and squeegee blade from squeegee
frame. Replace or rotate blade end for end to
allow a new edge to face forward (Figure 36).
To replace the rear squeegee blade, unlatch
retainer clamp and remove retainer band and
squeegee blade from squeegee frame. Replace or
rotate blade end for end or top to bottom to allow a
new edge to face forward (Figure 36).
FIG. 36
