OPERATION
Speed Scrub
t
2601 Cylindrical Brush (12–02)
11
WHILE OPERATING MACHINE
WARNING: Do Not Pick Up Flammable
Materials Or Reactive Metals.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
1.
Observe the amount of solution flow on floor. To
increase or decrease water flow, adjust the
solution control knob (Figure 16).
FIG. 16
2.
Periodically observe recovery tank for excessive
foam. If excessive foam appears, pour a
recommended foam control solution into recovery
tank.
ATTENTION: Do not allow foam or water to enter
float shut–off screen, vacuum motor damage will
result. Foam will not activate the float shut–off
screen.
3.
Always operate at a slower speed when scrubbing
around walls or obstacles.
4.
Always reduce speed to maintain control when
turning machine.
5.
If squeegee leaves streaks, raise and wipe blades
with a cloth. Pre-sweep area to prevent streaking.
6.
Overlap each pass by 51mm (2 in).
7.
Change brushes when worn.
8.
If you experience excessive brush vibration or
poor scrubbing performance, see ADJUSTING
SCRUB HEAD.
9.
Stay clear of floor obstructions, such as electrical
plates or grates, they will destroy brushes.
10. During brief stops, brushes and solution flow will
automatically stop when control grips are
released.
11. Periodically check battery meter discharge level.
When needle nears the red zone, recharge
batteries.
ATTENTION: Do not run machine when battery
meter needle is in the red zone, battery damage
will result.
12. While cleaning, view the clear tube at rear of
machine for remaining cleaning solution.
13. When solution tank runs dry, turn off solution
switch, and continue to vacuum until all dirty water
is consumed. Then drain recovery tank
(see DRAINING TANKS).
14. When cleaning on inclines, always clean moving
downward, never upward. Never climb inclines
that exceed 5 degrees, machine damage may
occur.
STOPPING MACHINE
1.
Turn solution switch off and continue to vacuum
until all solution is consumed.
2.
Release control grips.
3.
Raise squeegee.
4.
Turn machine off and remove key if equipped.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
EMERGENCY STOPPING (OPTION)
To stop machine in the case of an emergency, strike
the red power kill button located at rear of control
console. The power kill button immediately stops all
power to machine (Figure 17).
To reset power kill button, shut off all switches and
turn kill button to the right. Resume to normal
operation.
FIG. 17
