Noblelift AWPS23.56, Руководство по эксплуатации и безопасности

Страница: 37 / 100

37
Table 4-1. Battery Charger Flash Codes
4.8 PLATFORM LOADING
The platform maximum rated load capacity is shown on a placard located on the
platform and is based upon the following criteria:
1.
The machine is positioned on a firm, uniform surface.
2.
All braking devices are engaged.
3.
Refer to Section 6 for the maximum platform capacity.
NOTE: It is important to remember that the load should be evenly distributed on
the platform. The load should be placed near the center of the platform
when possible.
Flash(s) Fault Fault Removal
1 Battery voltage high
Auto-recover - Indicates a high battery pack
voltage
2 Battery voltage low
Auto-recover - Indicates either a battery pack
failure, battery pack not connected to charger or
battery volts per cell is less than
0.5 VDC. Check the battery pack and
connections
3 Charge time-out
Indicates the batteries did not charge in the
allowed time. This could occur if the batteries
are a larger capacity than the algorithm
is intended for or if the batteries are damaged
old or in poor condition.
4 Check battery
Indicates the batteries could not be trickle
charged up to the minimum voltage per cell level
required for the charge to be started.
5 Over-temperature
Auto-recover - Indicates charger has shut down
due to high internal temperature
6 QuiQ fault
Indicates that the battery will not accept charge
current, or an internal fault has been detected in
the charger. This fault will nearly
always be set within the first 30 seconds of
operation. Once it has been determined that the
batteries and connections are not
faulty and fault 6 is again displayed after
interrupting AC power for at least 10 seconds,
the charger must be brought to a qualified
service depot.