Noblelift AWPS23.56, Руководство по эксплуатации и безопасности

Страница: 36 / 100

36
4.7 BATTERY CHARGING
Operation
NOTE: Be sure that machine is parked in a well ventilated area before charging
begins.
ONLY PLUG THE CHARGER INTO A PROPERLY INSTALLED AND
GROUNDED OUTLET. DO NOT USE GROUND ADAPTORS OR MODIFY
PLUG. DO NOT TOUCH NON-INSULATED PORTION OF OUTPUT
CONNECTOR OR NON-INSULATED BATTERY TERMINAL.
ALWAYS DISCONNECT THE AC SUPPLY BEFORE MAKING OR BREAKING
THE CONNECTIONS TO THE BATTERY BEFORE CHARGING.
DO NOT OPEN OR DISASSEMBLE CHARGER.
DO NOT OPERATE CHARGER IF THE AC SUPPLY CORD IS DAMAGED OR
IF THE CHARGER HAS RECEIVED A SHARP BLOW, BEEN DROPPED, OR
OTHERWISE DAMAGED IN ANY WAY.
The battery charger receptacle is located at the right rear of the machine near the
ground control panel.
1. Connect the charger to a grounded outlet.
2. On the Battery Charger, the charger will automatically turn on and go through a
short LED indicator self-test. All LED’s will flash in an up and down sequence for
two seconds.
3. The batteries are fully charged when green light on the battery charger status
panel is illuminated.
NOTE: If the charger is left plugged in, the charger will automatically restart a
complete charge cycle if the batteries voltage drops below a minimum
voltage or 30 days has elapsed.
Battery Charger Fault Codes
If a fault occurred during charging, the red "Fault" LED will flash with a code.
The number of flashes corresponds to the error. Refer to Table 4-1, Battery
Charger Flash Codes.