11
Fig. 6:
Axle assembling
Practice maintenance work according to regular Inspection. This truck is not designed to be water resistant,
therefore use it in dry atmospheres.
4. COMMISSIONING, TRANSPORTING, STORAGE/
REASSEMBLING
a.
Commissioning – Tiller assembling
After receiving our new scissor lift pallet truck you may
have to do following before firstly operating the truck:
•
Check if are all parts included and not damaged
•
Do the work according to the daily inspections as well
as functional checks.
•
Eventually assemble the truck according to following
instructions.
The commissioning weight is approximately 10kg / four-
pack
higher than the product weight.
Before assembling, please make sure, that the following supplied parts are included and not damaged:
•
1 pc axle with hole (4)
•
2 pc dowel pin (5) [one is already assembled with
the axle]
•
1 pc pre- assembled tiller arm (1)
•
1 pc pre- assembled chassis with pump unit (6)
•
Connect the plug(optional for electric model)
（
Fig.
1, pos. 10
）
Note: The marked number on the tiller arm
package and the chassis should be the same.
When attaching the handle, you had better squat
just in front of the pallet truck.
a) Insert the tiller arm(1) into the pump piston
,
then
use a hammer to insert the axle with hole into the
hydraulic pump and tiller arm from the right to the left
(Fig. 6 ).
b) Set the control lever of the handle to the
‘LOWER’ position, then pass the adjusting nut, adjusting bolt
through the hole of the axle with your hand
(Fig. 7).
c) Press the tiller arm down; take away the pin
(2, Fig. 5).
d) Set the control lever of the handle to ‘QUICK LIFT’ (LIFT)
position, then raise the lever plate with the pin (2, Fig. 5) and
insert the adjusting bolt into the front slot of lever plate. Note:
Keep the adjusting nut under the lever plate.
Fig.5
Tiller assembling
（
symbolic
）
(1 Tiller arm / 2 Pin / 3 Nut / 4 Axle with hole /
5 Dowel pin / 6 Chassis with pump unit)
Fig. 7: Side view
（
symbolic
）
