Nobis A10C ROUND, Инструкция по установке, использованию и техническому обслуживанию

Страница: 33 / 40

Use and Maintenance Manual model “A8 - A10 V/C ROUND/TOP”
33
ENGLISH ENGLISH
Lift the “cold lever”, supplied with the product,
to release the door and allow
fire door opening, as in the figure below:
To extract the flame trap, lift it slightly as in the figure
below:
Remove it by bringing the lever towards you with
slight movement downwards as in the figure below:
Each alarm condition causes the appliance to
immediately switch off. Press the switch on key P3
to reset the alarm. Before switching back on the
appliance, check
signalling is resolved.
18 CLEANING THE APPLIANCE
Before carrying out any cleaning operation on the ap-
pliance, take the following precautions:
• switch off the product and in “OFF” status
disconnect the power supply cable;
• ensure all the parts are cold to touch;
• ensure the combustion ash is
completely out.
To clean the surfaces, on the painted metal parts,
use a cloth soaked in water and soap.
Use of abrasive detergents or diluents causes
damage to the surface of the product.
18.1 CLEANING THE FIREPLACE
Open the fire door, using the specific
tool and:
• vacuum the slide bringing the ash to the brazier; •
dismantle the flame trap, vacuum the compartment
hidden by the flame trap (paying utmost attention
not to damage the sensor placed behind the flame
trap).
• the vermiculite does not require cleaning, in any
case if you intend eliminating the soot dust, only use
a soft bristle brush.
Please carefully adhere to the following
instructions for correct cleaning of the appliance.
Non-compliance could cause its
malfunctioning.
OPERATING PROCEDURE:
Open the fire door using the “cold lever”
supplied with the product and Insert the “cold lever”
in the specific compartment, as indicated
in the figure below: