NKT Photonics Koheras ACOUSTIK, Руководство по эксплуатации продукта

Страница: 38 / 96

Connecting power
38
Note: When no accessories are connected to the ACOUSTIK system as is the
typical case, place the bus defeater on the rear panel External bus connector of
the ACOUSTIK.
Figure 15 External bus defeater
Connecting power
Power is supplied to an ACOUSTIK system through its rear AC input connector.
The connector is a standard C14 inlet designed for use with a C13 AC power cord.
Electrical and cable specifications are listed in
Table 4 .
Table 4 Power specifications
Connecting modulation signals
Input and output wavelength modulation signals are described in the document:
Koheras BASIK Product Guide
Connect modulation signals to the D-sub 9 pin connector on the rear panel, see
“Modulation input/output” on page 85 for the pin assignments of the connector.
Connecting the trigger input or output
The laser includes a trigger logic input/output pin of the Modulation connector
(see Table 11 ). When uses as an input, a signal on the pin 1 of the connector can
trigger emission, and when set as an output, a signal on the pin indicates laser
emission.
Item Description
Maximum power
consumption 300 W
AC mains Input 100-240 VAC @ 50-60 Hz
AC connector (inlet) IEC 60320 C14 connector
Power cord Regional AC power cord with IEC 60320 C-13 connector.