IS-Dev Kit-8 User Manual
7850 East Gelding Drive • Scottsdale, AZ 85260-3420
IS-Dev Kit 8 Users Manual A.doc
Page 7 of 31
Toll Free
1.877.2BUYNKK (877.228.9655)
•
Phone
480.991.0942
• Fax
480.998.1435
www.nkkswitches.com
1209
For visual illustration, through out the document blue is used to show a top switch action, green is a middle
switch action, a red is the bottom switch action, and a dotted violet line is the timer action.
Illustration 1, Switch and timer actions as described by the attributes.
The Hex number shown is the address of an image that is displayed.
Attribute Information (Attribute Block)
There are seven attributes per image.
1.
Top Switch Address. The address of the image to be displayed if the top switch is pressed.
When the top switch is pressed:
A.
If the address is set to zero there will be no change.
B.
If the address is set to a positive number the image at the address is displayed and the
attributes at the address become active.
2.
Middle Switch Address. The address of the image to be displayed if the middle switch is pressed.
When the middle switch is pressed:
A.
If the address is set to zero there will be no change.
B.
If the address is set to a positive number the image at the address is displayed and the
attributes at the address become active.
3.
Bottom Switch Address. The address of the image to be displayed if the bottom switch is pressed.
When the bottom switch is pressed:
A.
If the address is set to zero there will be no change.
B.
If the address is set to a positive number the image at the address is displayed and the
attributes at the address become active.
4.
End Address. The address of the last image to be displayed in an image sequence starting at the
current address and ending at the end address where the speed of the sequence is based on the timer
value.
A.
If the timer is set to zero this is attribute is ignored.
