IS-Dev Kit-8 User Manual
7850 East Gelding Drive • Scottsdale, AZ 85260-3420
IS-Dev Kit 8 Users Manual A.doc
Page 6 of 31
Toll Free
1.877.2BUYNKK (877.228.9655)
•
Phone
480.991.0942
• Fax
480.998.1435
www.nkkswitches.com
1209
4.
Operational Overview
Power-up and Brightness Adjustment:
When the power is turned on, the OLED displays the image below and allows for brightness adjustment.
There are 16 level of brightness 0,1,2,3,4,5,6,7,8,9,A,B,C,D,E and F where F is the maximum brightness. The
level of brightness is displayed in the middle of image. After power up, the display is at the maximum
brightness level (F). Pressing the bottom switch will make the display dimmer. Pressing the top switch will
make the display brighter. The OLED rated life of 52,000 hours is based on the maximum brightness. The
dimmer the level is set the longer the life of the OLED. Any switch activity will keep the unit in this mode.
After 2.6 seconds of user inactivity the controller will move into the main operations mode.
Main Operational Mode
The IS-DEV KIT-8 is programmed with factory default images. The user can change the images and
programming through the use of attributes. The images are pictures to be displayed. The attributes are user
defined information on what image to display based on the switch activity and when the timer expires. After the
brightness adjustment mode the OLED Rocker displays the image at address 1 and uses the attribute
information of address 1. There is room for 65,535 images and attributes (address 1 to 65535) in memory.
The controller associates one address to each image and the display shows the image at the associated address.
Each address has a group of seven attributes which together is called an Attribute Block. The function of the
Attribute Block is to tell the controller what image to display next either when the switch associated with that
particular address is pressed or when the timer expires. These are called actions.
