IS-Dev Kit-8 User Manual
7850 East Gelding Drive • Scottsdale, AZ 85260-3420
IS-Dev Kit 8 Users Manual A.doc
Page 21 of 31
Toll Free
1.877.2BUYNKK (877.228.9655)
•
Phone
480.991.0942
• Fax
480.998.1435
www.nkkswitches.com
1209
[address] is two bytes with value of 0001H to FFFFH sent as ASCII HEX format.
[attribute block] is fourteen bytes transmit in ASCII HEX format.
The address and attribute block are saved at this address. When the controller reads the attribute block it
compares the requested address to the saved address and if they do not match controller knows that the
attribute block is not programmed and ignores it.
Image and Attribute block
Attribute Block:
An attribute is handled as a block of 14 bytes. Table below show the transmit order of the data.
Byte
Description
1
High byte of action address for
Top Switch.
2
Low byte of action address for
Top Switch.
3
High byte of action address for
Middle Switch.
4
Low byte of action address for
Middle Switch.
5
High byte of action address for
Bottom Switch.
6
Low byte of action address for
Bottom Switch.
7
High byte of end address.
8
Low byte of end address.
9
Timer 1
10
Timer 2
11
High byte of action address for
Left Switch. Reserved. (0000)
12
Low byte of action address for
Left Switch. Reserved. (0000)
13
High byte of action address for
Right Switch. Reserved. (0000)
14
Low byte of action address for
Right Switch. Reserved. (0000)
Command to upload an attribute block
This command uploads an attribute block from the EEPROM location to the host.
command format:
2BH
55H [address]
transmit format:
(xxH) (xxH) (xxAH)
