NKE Multifunction SL50, Руководство пользователя и инструкция по установке, Страница: 20 / 23

- 20 –
SL50
User guide – 33-60-022-000
3.8 SL50 and remote control initialisation
At first power-up, you must initialise the
SL50
so that an address is assigned to it. The display
is delivered with the address set as
0
. During the initialisation, it will automatically insert itself in
the list of instruments and displays of the
TOPLINE bus
of your installation :
−
either as master, at the address
1
, if this address is available on the bus,
−
or as slave, if the address 1 is taken by a master, at an available address comprised
between
2
and
20
.
Likewise, the remote controls must also be initialised. Please refer to the remote control user
guide.
3.8.1 Initialisation procedure:
the SL50 is set at the address
0
-
your installation is powered off : disconnect the initialisation red wire from the
init
terminal
(GND),
-
power up your installation : the
SL50
then performs an auto-test,
-
when the message «
connect the red wire
» appears, reconnect the red wire on
init
(GND) :
the
SL50
takes an address available on the bus,
-
the SL50 is then initialised.
3.8.2 Reinitialisation procedure :
the SL50 already has an address between 1 and 20
You may need to reinitialise the
SL50
, for example to have another address assigned to it.
-
your installation is powered off : disconnect the initialisation red wire from the
init
terminal
(GND),
-
power up your installation : the SL50 performs an auto-test then takes the address
0
,
-
when the message «
connect the red wire
» appears, reconnect the red wire on
init
(GND) :
the
SL50
takes an address available on the bus,
-
the SL50 is then initialised.
CAUTION
:
−
the remote control(s) of your installation must be assigned to an address higher than the
one of the
SL50
. To achieve that, you must first initialise the
SL50
then the remote
control(s).