Njoy Balder 10000, Руководство пользователя

Страница: 19 / 43

36 37
Engli
sh
Română
Step 6. Modify the battery pack to meet the setting number in control
board carefully.
NOTE!
Most of Balder UPS’s require only setting the number of batteries, not the charging
voltage and charging current; please use below section only if your UPS has
charging voltage and charging current jumpers available.
6.9.3. Operation of changing charging voltage
Step 1. There are 5 jumpers on the
charger board. Please refer
to the below table to modify
charger voltage based on
the number of batteries on
battery cabinet.
Jumpers on the charging board
Battery nr
in battery
cabinet
Charger
voltage (V)
JP01 JP02 JP03 JP04 JP05
16
218 0 0 0 1
0
17
232 0 0 1 0
0
18
245 0 1 0 0
0
19
259 1 0 0 0
0
20
273 0 0 0 0
0
NOTE!
0 = no jumper; 1 = connect with jumper.
Step 2. After completing the above steps, put the cover back, switch on
the battery breaker for long-run model and switch on the input
breaker. Then, the UPS will enter Bypass mode. If the UPS is
in maintenance Bypass mode, turn the maintenance switch to
“UPS” position and then turn on the UPS.
6.9.4. Operation of changing charging current
Step 1. This operation is only available for professional or qualified
technicians.
Step 2. Turn off the UPS. If the load couldn’t be cut off, you should
remove the cover of maintenance bypass switch on the rear
panel and turn the maintenance switch to “BPS” position first.
Step 3. Switch off the input breaker, and switch off the battery breaker.
Step 4. Remove the cabinet cover, and disconnect battery wire for
standard model.
Charging board
Control board
Step 5. Then modify the jumpers on
the charger board to set the
charging current (refer to
table below). Be careful that
the maximum charge current
should not exceed the
battery accepted charging
current.
Jumpers on the charging board
NOTE!
For most of Balder 6000/10000 UPS’s changing charging current is available from the
menu. Please see parameter 17 settings on page 26. If this parameter is not available on
the menu, changing the charging current can be done by following the procedure below: