Single Digit Nixie Tube Clock ‘Z566’
www.pvelectronics.co.uk
- 10 -
4.5
Inductor L1
Place L1 in position, and ensure it is as close to the board as
possible. The leads of the component may not match exactly the
spacing on the board – this is perfectly normal. You can slightly
form the leads so it is a nice firm and snug fit to the board. Solder
and trim the leads as short as possible.
4.6
R1, R2, VR1.
Bend the leads of the resistors as show in figure 7 below.
Now place and solder in R1, R2 and VR1 as shown:
Figure 7: Resistor
leads formed for
mounting upright.
Figure 6: Correct
placement of C1, C2,
C5
Figure 8: R1, R2, VR1
