Nivus osm-f, Инструкция по эксплуатации

Страница: 52 / 103

Instruction Manual
OCM F
Page 52 OCM F - Rev. 04 as of 18.02.2014
®
Sensor type No.
Pressure trans. 01
Level measurement by a KDA combi sensor which is directly
connected to OCM F according Fig. 7-5.
Offset installation e.g. due to sedimentation or high dirt load is possible.
Level measurement in case of flooding is possible as well.
1 Sedimentation or soiling
Fig. 9-28 Sensor type 1: Pressure int.
Constant level 02 Use this point to set parameters for constantly full filled pipes and chan-
nels. Such applications normally do not require level measurements.
The constant filling level must be set under >value< and is used for flow
calculation. This parameter is helpful too at initial start-up or in case of
performing tests without having level values available.
Fig. 9-29 Sensor type 2: Constant level
ext. Sensor 03 In this case the level is measured by using external transmitters such
Type NivuMaster with echo sounder or an external 2-wire sensor such
as NivuCompact (non-Ex) or i-Series sensor for Ex-Zone 1. Connect as
shown in Fig. 7-8, Fig. 7-11 or i-Series connection plan Fig. 7-9.