6
5. GRINDING WHEELS
WARNING
The maximum operating speed marked on the
Grinding Wheel, blotters, or packaging, shall equal or
exceed the rated speed on the grinder.
Use with Type 27 Depressed Center Grinding Wheels.
MAGW-40
Fig.5
MAG-50
Fig.6
MAGW-40
MAG-50
A
100mm (4”)
125mm (5”)
B
16mm (5/8”)
22mm (7/8”)
C
6mm (1/4”)
6mm (1/4”)
A : Diameter of the Grinding Wheel
B : Hole of the Grinding Wheel
C : Thickness of the Grinding Wheel
6. MOUNTING AND REMOVING GRINDING WHEEL
WARNING
Always turn off the air supply and disconnect the
air supply hose.
6-1. MAGW-40
Mounting
1 Hold the Driving Flange with Spanner supplied.
2 Insert the Outer Flange into the Grinding Wheel,
aligning the slot in the Outer Flange with the Key
in the Driving Flange.
3 Secure it firmly to the Spindle by tightening the
Wheel Lock Bolt with Hex. Socket Screw Key.
Removal
Hold the Driving Flange with Spanner and loosen
Wheel Lock Bolt with Hex. Socket Screw Key to
remove the Grinding Wheel.
Hex.Socket Screw
Driving Flange
Spanner
Grinding Wheel
Outer Flange
Wheel Lock Bolt
Fig.7
6-2. MAG-50
Mounting
1 Hold the Spindle with pushing the Lock Button.
2 Insert the Driving Flange into the Spindle to fit the
convex on the Spindle and groove of the Driving
Flange.
3 Insert the Grinding Wheel and Outer Flange into
the Spindle.
4 In case the thickness of the Grinding Wheel is
4mm or less, attach the Outer Flange up side
down.
5 Secure it firmly to the Spindle by tightening the
Outer Flange with Pin Face Wrench.
6 Secure Washer and Hex. Socket Button Head
Screw 6×15 firmly to the Spindle by tightening the
Socket Button Head Screw 6×15 with Hex. Socket
Screw Key.
MAGW40_MAG50_E.indd 6
13.7.4 3:23:52 PM
