5
1. USAGE
This tool is for grinding workpieces using a Type 27
Depressed Center Grinding Wheel.
2. CHECK THE CONTENTS OF THE PACKAGE
Check the contents and make sure that the tool does
not have any damage which may have occurred
during transportation. The contents should correspond
to the list as follows. In case of damage/missing
parts, please contact the sales agent from whom you
purchased the tool.
Package Contents
Qty
Check
MYTON MLG-25
1
Grinding Wheel GS #80
1
Hex. Socket Screw Key 5
1
Single Ended Spanner 19
1
Bushing R1/4×NPT1/4
1
Instruction Manual
1
Declaration of Conformity
1
Caution for Use
1
3. AIR SUPPLY
3-1. Air Pressure
Adjust air pressure with the air regulator to the
appropriate level for the pneumatic tool used.
Air pressure that is too low will stop the tool from
operating at full capacity.
Air pressure that is too high may cause damage to
the tool.
3-2. Air Line
(Fig.2)
Use a 9.5 mm (3/8”) I.D. connecting hose between
the compressor and the tool.
Drained water, etc., if flown into the tool, could
cause tool failure. Install an air filter between the
compressor and the tool.
!"$%&
*
Fig. 2
3-3. Lubrication
Install an oiler between the compressor and the tool.
Use the machine oil ISO VG-10. Failure to lubricate
as required may result in damage to the tool. Use of
oil that is too thick will reduce the performance of the
tool.
4. GRINDING WHEELS
WARNING
The maximum operating speed marked on the Grinding
Wheel, blotters, or packaging, shall equal or exceed
the rated speed on the grinder.
Use with Type 27 Depressed Center Grinding Wheels.
M6
B
A
2〜4mm
C
Fig. 3
MLG-25
A
58mm (2-9/32”)
B
9.6mm (3/8”)
C
3mm (1/8”)
A : Diameter of the Grinding Wheel
B : Hole of the Grinding Wheel
C : Thickness of the Grinding Wheel
