7
7. STORAGE
CAUTION:
When tool is not used, store it out of reach of
children.
Avoid storing the tool in a location subject to high
humidity. If the tool is left as it is used, residual
moisture on the inside can cause rusting. Before
storing, and after operation, oil the tool at the air inlet
with machine oil ISO VG-10 and run it for a short time.
8. MAINTENANCE
Supply additional appropriate amount of SUMICO
Sumitec 305 Grease into the Gear Case with about
once a month interval.
1. Loosen the Screw 4x12 and remove the Exhaust
Cover, the Toothed Washer CW-4, the Spacer,
the Exhaust Plate, and the Packing Cover.
2. Inject grease with a grease gun into the Grease
Port next to the Exhaust Port.
The outside diameter of the nozzle tip of the
grease gun must be 3mm or smaller. The nozzle
for grease nipple cannot be used for this grease
filling, because the shape of the Grease Port is
different from that of the nozzle for grease nipple.
3. Before putting back the Exhaust Cover, execute
idle running and wipe out excessive grease.
4. For assembly, see Fig.8 and put back the parts in
the reverse order of disassembly.
(M4 Screw)
Grease Port
Exhaust Port
2. Remove
Spacer
Exhaust Plate
Exhaust Cover
1. Loosen
Screw 4
×
12
Packing Cover
Toothed Washer CW-4
Fig. 7
Fig. 8
9. ORDERING SERVICE PARTS
●
For further operational and handling information or
for replacement of parts and components, contact
the company from whom you purchased the tool or
an authorized dealer.
●
In ordering parts and components give each part
number, part name and quantity required.
●
Use only NITTO genuine parts.
