NITRON TVT22, Руководство по установке, Страница: 15 / 16

Assembly Instructions
Do not force the adjuster at either end of its adjustment range as this may damage the
internal components.
WARNING
Spring preload is adjusted by turning the 14mm hex,
every complete turn of adjustment equals 1mm of spring
preload. There are 15 turns of adjustment in total and the
setting is referenced as the number of turns from the fully
anti-clockwise position. Adjusting spring preload will
change the amount of initial force required to compress
the springs a given distance in relation to their rate. This
will effectively raise (more preload) or lower (less
preload) the front of the bike thus changing the angle of
the fork and the bikes attitude.
15
Setup
Set the compression and rebound damping adjusters to
the baseline settings specified in your model specific
specification sheet. Adjustment is made by screwing the
adjuster clockwise to its full hard position and then
counting the clicks backwards from this point.