NITRON TVT22, Руководство по установке, Страница: 10 / 16

Assembly Instructions
Assembly Instructions
Your cartridge will arrive partially assembled. Unscrew the top cap from the piston rod and then remove the
spring spacer tube, upper spring seat and spring. Remove the two locknuts and washer from the piston rod,
bump stop spacer tube, plastic spacer, bump stop and lower spring seat.
Your cartridge kit splits the functions of compression and rebound damping into separate
fork legs. The rebound cartridge should be installed in the right hand fork leg and the
compression cartridge in the left hand leg. Be careful not to mix the two cartridges up, it is
advisable to work on one fork at a time.
WARNING
Step 1 Install The Cartridge Into The Fork
Install the cartridge into the fork. Apply Loctite 243
medium strength threadlock to the bolt with a new
crush washer and tighten the cartridge to the fork
bottom. Refer to your owners manual for the correct
torque setting.
Step 2 Filling The Fork With Fluid
Pour approximately half of the bottle of suspension
fluid into the fork leg making sure that it easily
covers the top of the cartridge body tube.
For the best damping performance it is essential to use Nitron 02 suspension fluid.
WARNING
10