Operation
1. Connect the headlamp cord (or extension cable) to the Power Module.
2. Press and release the headlamp power button to turn the light on. Cycle through the three brightness
levels by pressing and releasing the power button.
3. To access the daylight visible flash mode, press and hold the power button for greater than 3
seconds.
4. To turn the light off from either normal or flash mode, press and hold the power button for greater than
1 and less than 3 seconds.
Mounting the Power Module
1. Thread the velcro strap through the slots on the top of the Power Module.
2. Attach the concave surface of the Power Module to a safe, convenient location
on the handlebars, stem or frame, placing the velcro strap over the mating surface.
Attaching Helmet Mount to Helmet
1. Unclamp the straps on each side of the helmet mount and pull them free.
2. Position the mounting plate as close to the centerline of the helmet as possible, orienting the
snap to the rear.
3. Feed each strap into and out of two helmet vents, circling each strap back to the upper edge of the
corresponding clamp.
4. Fasten the straps by inserting them into the clamps.
Mounting Headlamp to Helmet Mount
1. Remove helmet mount body from the base. (Fig A)
2. Slip the O-ring mounting strap into the slot of the helmet mount body with the pull tab pointing
forward. (Fig B)
3. Place the O-ring mounting strap into the front slot of the handlebar mount. (Fig C)
4. Twist the handlebar mount back into its original position. Tighten the handlebar mount screw.
5. Stretch O-ring and pull up, around back of helmet mount body and loop it over and into the back
slot on the head mounting assembly. (Fig D)
6. Snap helmet mount body into helmet mount base. (Fig E) Position light where needed.
E
A
B
Battery Charging and Care
The smart charging circuitry is housed in the Power Module and will recharge a fully discharged
battery in 4
½
hours or less. Charging time using USB power may vary depending on computer.
1. Plug the AC Adapter into the Power Module and then into the wall socket.
2. Unplug the AC Adapter from the Power Module and wall socket, grasping the connectors rather
than the cables.
3. Leaving the Power Module and AC Adapter or USB Cable connected indefinitely will not harm the
battery.
Run Time
The MiNewt Mini 350 - USB™ will run up to:
Run time is an approximation and will vary
NiteRider Technical Lighting Systems
8295 Aero Place, Suite 200
San Diego, CA 92123 USA
800.466.8366
www.niterider.com
C
D
Light Level
High
Med
Low
Time*
2:00
4:00
6:00
Lumens
350
200
125
