NISSCI DS-1031, Инструкция по эксплуатации

Страница: 47 / 60

47
ENG
BATTERY INSTALLATION
1. Open the battery compartment cover (fi g.2).
2. Install four “AA” type batteries into the compartment.
Make sure that the polarities correspond to the (+) and (–)
marks inside the battery compartment (fi g.3).
Batteries can be easily installed or removed as their (-)
ends are pushed against the spring.
You may use nickel hydride rechargeable batteries.
These batteries can not be charged with this product.
Use the designated battery charger.
3. Close the battery compartment cover.
Do not force the battery cover into position.
Battery symbol will fl ash when
battery power is low.
Measurement can not be made while
the symbol is displayed. Replace the
batteries. All four batteries need to be
replaced with new ones; do not mix
new and old batteries or diff erent
batteries.
The symbol might appear only during
measurement although you can review
readings in memory. This is because more
battery power is required for conducting a
measurement, e.g. infl ating the cuff , than
displaying the readings in memory. Please
have the batteries replaced. The enclosed
batteries are for monitoring, and their life
may be shorter than that of commercial
batteries.
The used electrical and electronic
products are not household waste.
Follow your national/local recycling
rules to dispose of them properly.
Operation With AC Adaptor
AC Adapter socket is located at the side of the device.
Connect the AC Adapter jack to the device fi rstly and
after supply AC Adapter plug into the power outlet, press
«START / STOP». To switch off the device after fi nishing
the measurement press «START / STOP», unplug the AC
Adapter from the power outlet and disconnect AC Adapter
from the device.
WARNING!
If you will switch off AC Adapter
without batteries in the device
all information stored in memory
(results of measurements, date and
time) will erased. If you want to save
this information, do not remove
batteries from the device when using
the AC Adapter.
ADJUST DATE AND TIME AND ACTIVATE THE CLOCK
Date and time can be set after installing the batteries.
Set the time guarantees the preservation of the measurement results with the correct date and time.
There is a possibility of measurement of pressure and pulse rate without setting date and time.
Touch “SET” KEY and keep your fi nger touched to the key until “2011” starts fl ashing.
Clock is set in the order of year, month, day, hour and minute.
The fl ashing number increases with and decreases with . The number will be fast-forwarded
if you keep your fi nger on the key. Touching “SET” will fi x the number and the next article will
fl ash. Touching “START/STOP” will terminate the setting.
IMPORTANT! If the date and time have been set, current time will be shown on the display when
the device is turned off .
Fig.2 Fig.3