1
．
Inspection
28
No.704-2010-01
Move the tray to the right
end, and also change
TABLE POS OFFSET so
that a clearance of
0.5mm is present
between the arm and the
tray.
④
Axis-Y Up
Lift up the tray.
Make sure that the
projction of the arm fits
into the hole of the tray
and the tray and the rack
are in parallel.
If they are not in paralle,
loosen the screw of the
arm and adjust the
parallelism.
⑤
Axis-X Out
Pull out the tray.
Make sure that the tray
detection sensor
responds to the tray.
Adjust the angle and
position of the sensor if
the tray is not detected.
* The side of the sensor
lights up in red when
the tray is detected,
⑥
Axis-Y Origin
The tray moves to the Y-axis home
position.
Designate the boat
No.10.
