ninjakitchen.com
ninjakitchen.com
USING THE DISC ASSEMBLIES
(discs vary by model)
1
Place motor base on a clean, dry, level surface such as a countertop or table,
then plug in the unit.
2
Lower the Precision Processor® Bowl onto the motor base and rotate clockwise
until it clicks into place.
3a.
REVERSIBLE SLICING/SHREDDING
Use the plastic grip to
place disc over spindle with the desired output facing up.
Use the side labeled SLICER for slicing and the side labeled
SHREDDER for shredding.
3b.
ADJUSTABLE SLICING
Use dial on disc to select the desired
thickness (0.3–8mm). Then use plastic grip to carefully place
disc over disc spindle. Ensure disc is NOT on the S (storage)
setting before installing it. Return disc to S position after use.
3c.
REVERSIBLE SHREDDING
Use the plastic grip to place the
disc over the disc spindle with the desired shredding size
(either COARSE or FINE) facing up.
4
Place the feed chute lid on the bowl and turn clockwise until you hear a click,
indicating the lid is locked in. Based on the ingredient, use the smallest possible
feed chute opening for best slicing and shredding results. Press the Power
button to turn unit on.
5
Prior to slicing or shredding, prep ingredients to fit the feed
chute opening. Cut both ends off ingredients to create flat
surfaces. Trim tapered ingredients like carrots to make them
more symmetrical. Ensure cheese is well chilled.
DO NOT
slice
or shred frozen cheese. Keep ingredients as steady as possible
when pushing through the feed chute to minimize waste.
6a
If using the small or medium feed chute opening, select
DISC
or
LOW
.
The disc will begin spinning. Add ingredients through the feed chute
on the lid.
6b
If using the large feed chute opening, place ingredients up to, but
not exceeding, the
CHUTE MAX FILL
line. Insert the pusher into the
feed chute, then select
DISC
or
LOW
. The disc will begin spinning.
7
If using the Auto-IQ® program,
DISC
, the disc will automatically
stop spinning at the end of the program. If using the manual
program
LOW
, press the button again, or wait for the unit to
come to a complete stop after 60 seconds.
8
To remove the lid, press the button on the feed chute lid near
the handle to unlock, then turn the lid counterclockwise. Lift
the lid from the bowl.
9
Remove the disc assembly by grasping the plastic grip, then
carefully lifting the disc out of the bowl. Then, grasp the spindle
by the top of the shaft and lift it out of the bowl.
10
To remove the bowl from the motor base, turn the bowl
counterclockwise and then lift it up.
11
Press the Power button to turn the unit off, then unplug the
unit. Refer to the Care & Maintenance section for cleaning and
storage instructions.
IMPORTANT:
• Use only the DISC program or LOW setting when using the disc assemblies.
• If the control panel is flashing, this means the lid, bowl, or food pushers are not locked in place
correctly. Review steps to ensure you are installing all components correctly.
NOTES:
• Ensure the desired side is facing up on the reversible slicing/shredding disc or reversible shredding
disc before use.
• Ensure the desired thickness is set on the adjustable slicing disc before use.
• The 3-part food pusher separates into a small, medium and large food pusher to guide ingredients
through the different size feed chute openings. Use the small feed chute opening for ingredients like
carrots, the medium feed chute for ingredients like cucumbers and zucchini, and the large feed chute
for ingredients like potatoes.
• The large food pusher must be inserted in the feed chute for the unit to run.
5"
5"
