23
Operating Instructions - GALAXY VISITOR 3 RTF FTR 2.4 GHz No. NE2529M2
No. NE2529M1
After repairs
Checking the direction of motor rota-
tion
If you have to carry out repairs to the mo-
del, it is essential to check the direction of
rotation of all the motors (see illustration).
Motor sockets on the circuit board
Motor lead "A" = Socket "A" on the circuit board.
Motor lead "B" = Socket "B" on the circuit board.
Motor lead "C" = Socket "C" on the circuit board.
Motor lead "D" = Socket "D" on the circuit board.
CAUTION:
check that the motor leads are correctly connected
after carrying out repairs.
5. Check that the model is successfully bound to the transmitter
(the red Status LED glows constantly).
6. Now wait a further two seconds before releasing the right-
hand stick. The GV 3 is now in programming mode.
Programming
1. Selecting the video switch: you can use a rotary knob, a two-
position switch or a three-position switch for the function. If you
wish to use a rotary knob, rotate it from one end-point to the
other and back three times. If you wish to use a two-position
switch, move it from one end-point to the other and back three
times. If you wish to use a three-position switch, move it bet-
ween two positions and back three times.
2. Selecting the still photo switch: identical procedure to selecting
the video switch.
For the procedures described above, the end-point of the rotary
knob or switch is the base setting, which is stored. This means
that the function is activated when the transmitter control is mo-
ved away from the base setting.
Quitting programming mode
Once you have adjusted the switches, move the right-hand stick
fully to the left to leave programming mode.
front
rear
left
right
front
A
D
B
C
