Nilfisk-Advance SH TRUCK, Инструкция по эксплуатации

Страница: 26 / 59

26
SH TRUCK
Original Instructions
E1
E4
E5
E6
Symptom Reason Action
> Water inlet fi lter clogged up • Clean fi lter (see sect. 6.3).
No working pressure > Nozzle clogged up • Clean nozzle (see sect. 6.4).
> No inlet water • Check that the shut off cock
of the water inlet is open.
Check that the water supply
meets the requirements
(see section 3.4).
> High-pressure cock of outlet • Close all high-pressure
point open cocks not in use.
Machine starts and > Leaky hose/ • Repair leak.
stops pipeline/spray handle
7.2 Error messages
If your SH TRUCK does not heat the water although the white “Heating” push button (5) has been acti-
vated, the “overheat melting fuse” has blown. This fuse is located within the machine and MUST ONLY
be exchanged by an Nilfi sk service technician.
Error Message
(red STOP light fl ashing) Reason Action
Illegal sensor comb. > Lack of water • Check your water supply
– open?, suffi cient pressure?
• Check and clean inlet fi lter,
section 6.3.
> Declutching of thermal relay • Check ventilation.
or motor winding protector • Check fuses.
> Defective or mal-adjusted • Call Nilfi sk service.
fl ow sensor / pressure switch
Flow failure > Defective or mal-adjusted • Call Nilfi sk service.
fl ow sensor
No fl ame detected > No fl ame is detected when it • Check your fuel supply,
should be present and refi ll is nescessary.
> Fuel fi lter clogged • Call Nilfi sk service.
> Flame sensor soothed or • Call Nilfi sk service.
defective
Illegal fl ame detected > Flame detected when it should • Flame sensor not mounted
NOT be present in place. Mount sensor.
> Flame sensor defective • Call Nilfi sk service
Red STOP light fl ashing > Shortage of oil in h.p. pump • Top up with oil.
Display shows hour counters