Nilfisk-Advance SelectSweep, Руководство оператора и каталог запасных частей

Страница: 4 / 11

Sweeper hard to push 1. Side broom set too low 1. Adjust side broom
2. Main broom set too low 2. Adjust main broom
3. Large object trapped 3. Remove object
Poor pickup 1. String or other foreign 1. Remove string or
object wrapped or object
lodged in main broom
2. Dirt hopper full 2. Empty hopper
3. Main broom too high 3. Adjust main broom
4. Side broom too high 4. Adjust side broom
Excessive dust during 1. Dirt hopper full 1. Empty hopper
operation
2. Leak in floor seal 2. Replace damaged seal
3. Sweeping pace too fast 3. Reduce speed and raise
sidearm if cleaning
large, open area at a
fast pace
Streaks or patches Some types of line dirt Remove any build-up in
left behind sweeper will build up in housing main housing
behind main broom
Troubleshooting Chart
Symptom Possible Cause (s) Corrective Action
EMPTYING DIRT HOPPER
1. To empty the dirt hopper, lift up on the handle
located on the front of the hopper, and empty
contents into a proper container.
2. Replace dirt hopper back on sweeper by placing
front edge of hopper on sweeper frame.
3. Apply downward pressure until the hopper is in its
proper position.
4.The dirt hopper should be emptied after each use,
or as required. A full dirt hopper will affect the
sweeping efficiency of the push sweeper.
Maintenance
1. After each use, check for materials which may
have become wrapped around brushes or wheels,
and remove immediately.
2. Do not lubricate gears, clutch or other internal
parts.
3. Inspect rubber dust seals periodically for wear or
damage; replace as required.
4. Inspect the main broom periodically for wear;
replace when the bristles are worn to a length of
1
1 /
2
inches or less. The main broom can be easily
replaced by removing three screws from each half.
The same screws can then be used to attach the
replacement broom.
5. Side broom should be inspected periodically for
wear; replace when (with the adjustment in the
down position) less than
1 /
3
of the bristles come in
contact with the surface. The side broom can be
easily replaced by removing the screws from the
brush holder and reassembling the replacement
brush, using the same hardware.
4
Sweeper
Frame
▲
▲
Dirt
Hopper
- Emptying Procedure
Figure 7