Nilfisk-Advance RS 501, Руководство пользователя

Страница: 119 / 162

USER MANUAL ENGLISH
RS 501 33015501(3)2008-02 A 31
ENGINE COOLANT LEVEL CHECK
Empty the hopper (12, Fig. G); if it contains a small quantity of waste, it is not necessary to dump it.
Drive the machine on a solid and level ground, then engage the parking brake (7, Fig. E).
Lift the hopper (12, Fig. G), according to the procedure shown in the relevant paragraph.
Turn off the engine, by turning the ignition key (17, Fig. D) counterclockwise, to the end of stroke, then remove it.
Open the right lid (16, Fig. G) by releasing the fasteners (17) with the supplied key.
Remove the lifted hopper locking pins (9, Fig. F) from the housings (10), and place them into the holes (11).
WARNING!
The coolant line is pressurized; do not perform any check until the engine has cooled down and, even if the
engine is cold, the tank plug (1, Fig. AF) must be opened with extreme care.
Check that the coolant level in the tank (2, Fig. AF) is between the minimum and maximum marks, as shown in the Diesel
Engine Manual. If necessary, unscrew the plug (1) and top up.
Coolant components:
50% of AGIP antifreeze
50% of water
After top up, tighten the plug (1).
Perform steps 3 to 6 in the reverse order.
ENGINE FUEL FILTER REPLACEMENT
Empty the hopper (12, Fig. G); if it contains a small quantity of waste, it is not necessary to dump it.
Drive the machine on a solid and level ground, then engage the parking brake (7, Fig. E).
Lift the hopper (12, Fig. G), according to the procedure shown in the relevant paragraph.
Turn off the engine, by turning the ignition key (17, Fig. D) counterclockwise, to the end of stroke, then remove it.
Open the left and right lids (4 and 16, Fig. G) by releasing the fasteners (5 and 17) with the supplied key.
Remove the lifted hopper locking pins (9, Fig. F) from the housings (10), and place them into the holes (11).
Empty the dust control system water tanks (17 and 21, Fig. F) according to the instructions shown in the relevant paragraph.
Remove the screw (23, Fig. F) and open the left tank (21) outwards.
WARNING!
Open the tanks (17 and 21, Fig. F) outwards, only if they are empty: each tank contains 120 kg of water
approximately.
Replace the fuel fi lter as shown in the diesel engine Manual.
Perform steps 3, 4, 5, 6 and 8 in the reverse order.
If necessary, fi ll the dust control system water tanks according to the procedure shown in Before Start-Up paragraph.
CAB AIR FILTER REPLACEMENT
Engage the parking brake (7, Fig. E).
Turn the ignition key (17, Fig. D) counterclockwise, to the end of stroke, then remove it.
Inside the cab, remove the screw (1, Fig. AG), then remove the panel (2).
Unscrew the knobs (1, Fig. AH) and remove the panel (2).
Remove the cab air fi lter (1, Fig. AI).
Install the new fi lter (1, Fig. AI) with the arrows (2) pointing in the direction shown in the fi gure (direction of the air fl ow).
Perform steps 3 and 4 in the reverse order.
1.
2.
3.
4.
5.
6.
7.
•
•
8.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
1.
2.
3.
4.
5.
6.
7.