Nilfisk-Advance Hybrid Typhoon, Инструкция по применению

Страница: 22 / 112

22
Eng
lis
h (
EN
)
9.10.1. Error description
Example of Error log screen display :
All error occurrences will be stamped with date and time.
E indicates Error number. P indicates Pump number.
E0\P1
2006-01-01
12:00
C1 Inverter
Error
BA E0\P1
2006-01-01
12:00
C1 Inverter
Error
BA
The error log stores up to 1000 occurrences. When max. memory is reached, the errors will
be deleted according to ”First in” First out” principle.
9.10.2. Error List
Error Cause Remedy
C1 Inverter
Error
1. Frequency inverter in error state 1. Switch off the power on the
service switch. Wait 180 sec.
Switch on the unit again. If error
still occurs, please contact your
local service technician.
C2 Low Supply
Pressure
1. Insufficient water supply 1. Secure sufficient water supply
pressure.
2. Check inlet filter for impurities/
rinse filter
3. Contact your local service
technician.
C3 High Water
Temp.
1. Water pump top temperature is above 80°
2. Water consumption is too low (pump column has
been overheated)
1. Lower the inlet water temp.
(max 70°C)
2. Secure sufficient water con-
sumption
3. Contact your local service
technician.
C4 High Motor
Temp.
1. Insufficient cooling of motor
2. The ambient temperature is above 40°
1. Secure that all air channels are
open and not blocked by impuri-
ties
2. Lower ambient temperature
C5 Phase seq.
Not correct
1. Phase sequence of phase L1, L2, L3 at 400V supply is
not correct.
1. Swap two of the phases, either
L1 and L2 or L2 and L3 on the
connection side (x10)
2. Contact your local service
technician
C6 Low Sensor
Supply Voltage
1. Voltage supply for sensors too low 1. Press “off” button
2. If error reoccurs, contact your
local service technician.
C7 No Response
Error
1. No communication between display and control board 1. Contact your local service
technician.