WHEEL DRIVE SYSTEM
3
Defect in potentiometer mechanism - follow instructions below.
•
Make sure that the orange, yellow and green wires are firmly connected to the potentiometer (see Figure
3).
•
See Figure 3. Check for loose set screws in pulley “B” or” C”.
•
If the wires and set screws are both secure, follow steps below.
•
Remove the plastic cover from the speed control.
•
Disconnect plug “A” from the speed control.
•
Connect an ohmmeter to the green and orange wires.
NOTE:
inserting the ends of paper clips into the
plug will help in the attachment of the test leads. The meter should read 2400 - 2600 ohms in neutral and
increase to 5000 ohms when the twist grips are turned to the full-forward position. If you
do not
get
these readings, follow potentiometer adjustment instructions. If you
do
get these readings, go to the next
test.
•
Connect an ohmmeter to the green and yellow wires. The meter should read 2400 - 2600 ohms in
neutral and decrease to 100 - 300 ohms when the twist grips are turned to the full forward position. If you
do not
get these readings, follow potentiometer adjustment instructions. If you
do
get these readings,
the potentiometer is OK - replace the speed control.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
TROUBLESHOOTING, (continued)
FIGURE 3
A
B
C
D
Orange
Green
Yellow
19
BA 500
Service Manual
