27 - FORM NO. 041324 / RETRIEVER 350B
Troubleshooting
PROBLEM
CAUSES
REMEDIES
It does not pick up heavy material
Broom pattern too light.
Adjust the pattern.
or leaves dirty traces while sweeping.
Worn broom.
Lower the broom or replace it.
The bristles of the broom are bent
Remove the wound material, straighten
or there are wire, strings, etc. bound.
the bristles by soaking in warm water.
Excessive dust left on the ground or
Clogged filter.
Clean filter.
coming out of the flaps.
Flaps worn or broken.
Replace.
Dust coming out of the fan.
Hole in filter or seal damaged.
Replace or repair
It throws the refuse forwards.
Front flap broken.
Replace.
The front flap is lifted by the broom.
Flap too long.
Replace.
Excessive broom wear.
Pattern too heavy.
Use a narrower pattern.
Excessive noise or altered sound
Material wound around the broom.
Remove.
of the main broom.
The main broom does not turn.
Transmission belt broken.
Replace.
Battery not keeping the charge.
Lack of liquid in the battery.
Top the level off after charging.
Battery element in short circuit.
Replace the battery.
Overloaded motor.
Check motor absorption.
Loose battery connection terminal.
Check and tighten.
Wires or strings wound on central broom
Remove.
Locked bearings.
Replace.
Too heavy broom pattern.
Adjust.
Battery discharging rapidly.
Charging time too short.
Adjust charging time.
Loose or oxidized poles.
Clean poles and tighten bolts.
The shaker motor does not work
Broken switch
Replace
Fuse burned out
Replace
Excessive motor consumption caused by:
-worn out carbon brushes
Replace
-dirty or worn bearings
Replace
The shaker motor fuse burns out
Excessive motor consumption
See above
Defective fuse
Replace
Cable short circuit
Check the electric system