INSTALL THE BRUSHES (CYLINDRICAL SYSTEM)
CAUTION!
Turn the machine OFF at the power switch, before changing the brushes, and before opening any access panels.
1
Make sure the Scrub Deck is in the RAISED position. Make sure the Power Switch
(B)
is off.
2
Unlatch and swing open the Scrub Deck Side Doors
(15)
.
3
See Figure 3.
Unlatch and swing open both Side Blade Assemblies
(AA)
.
4
Unhook the Latch
(AB)
on top of the Idler Assemblies
(AC)
and remove.
5
Slide the brush into the housing, lift slightly, push and turn until the tabs on the drive hub seat into the notches in the brush. NOTE: The idler is designed with
a snug
fi
t into the brush to reduce vibration. Re-install the Idler Assemblies
(AC)
make sure the tabs on the idler are inside of the weldment (as shown in
Figure 3). Secure with Latch
(AB)
. Close and latch both the Blade Assemblies
(AA)
and Scrub Deck Doors
(15)
.
FIGURE 3
AA
AB
AC
AC
4/2016
A - 15
56091168 - SC6000
ENGLISH - A
INSTRUCTIONS FOR USE
