2. After the device finishes starting up, the screens with signal readings will be displayed as follows (use
UP
and
DOWN
buttons to
switch the signal readings for two frequency bands).
L8
– LTE 800 MHz
L7
– LTE 700 MHz
OS -
Outdoor signal that the device receives from outside source (cell tower). This value is always measured as negative with the
sign “-” .
OP –
Output power. Can be negative with “-” or positive with “+”.
Note:
For optimal performance of the booster, the Output power must be positive.
Status
– Current working status of the system.
•
Good:
Booster is working very well, there should not be any adjustments needed.
•
OK:
The booster works, but not to the maximum. Coverage may be smaller. In order to cover a wider area, you need to
change the direction or position of the external antenna to get a stronger signal from the cell tower.
•
Weak:
The booster receives a weak outside signal from the cell tower. You need to change the direction or position of the
external antenna to get a stronger signal. When the coverage is satisfactory, you don't need to adjust anything else.
AGC
– Automatic Gain Control.
“
√
“
means thatthefunction activated, system working properly.
“×”
means thatAutomatic Gain
Control failed, system needs adjustment.
OSC
– Anti Oscillation function.
“
√
“
means thatthefunction activated, system working properly.
“×”
means thatAnti Oscillation
function failed, system needs adjustment.
3. Use
UP
and
DOWN
buttons to switch the screen pages further.
Max Gain –
The booster’s highest gain that is set by the factory.
