![background image](http://html1.mh-extra.com/html/niko/72-503/72-503_manual_1689514005.webp)
PM72-503_EN
EN
72-503
5
Special button combinations
A special button combination (SBC) can be used to enter/disable the configuration mode or perform a factory reset.
1 SBC: Enter the configuration mode
Select one contact (A0, A1, B0 or B1) of the double key dimmer switch, Bluetooth
®
.
1. Push and hold this button, together with the energy bow, for more than 7 seconds. Release.
2. Push and hold the same button, together with the energy bow, for less than 2 seconds. Release.
3. Push and hold the same button again, together with the energy bow, for more than 7 seconds. Release.
The dimmer switch will enter configuration mode (*) and transmit configuration telegrams whenever the selected button is pushed-released.
4. Push any other button to revert to normal mode
(*) If the configuration mode has been disabled (see 3 SBC), the dimmer switch will not enter configuration mode when executing the above procedure. Perform a factory reset to re-enable configuration mode.
3 SBC: Disable the configuration mode
1. Remove the central plate from the double key dimmer switch, Bluetooth
®
2. Push and hold the three contacts (A0, AI, BI) together with the energy bow for minimum 10 seconds. Release.
The configuration mode of the Bluetooth
®
dimmer switch is now disabled. Perform a factory reset to re-enable configuration mode.
4 SBC: Perform a factory reset
1. Remove the central plate from the double key dimmer switch, Bluetooth
®
2. Push all four contacts (A0, AI, B0, BI). These contacts can be released any time after the energy bow has been pushed. Keep the energy bow pushed for at least 10 seconds. Release.
A factory reset is performed. All parameters will revert to the default settings. The configuration mode will be re-enabled if it was disabled before and the NFC access will be restored if it was locked.
Two-way near field communication (NFC) device
1. Hold the NFC reader directly against the double key dimmer switch, Bluetooth
®
.
If you are using an NFC enabled smartphone, the NFC antenna is most likely located in the phone’s upper half. The double key dimmer switch, Bluetooth
®
has an NFC antenna located in the centre of the device.
2. Configure the dimmer switch using the software tool (for example Xicato
®
Control Panel) or smartphone app (Casambi® or Sylsmart
®
) which can be downloaded from iOS App store or Google Play store.
Examples:
Bluetooth
®
lightings system
App or software
Casambi
®
Ready luminaire
Casambi
®
smartphone app
Xicato
®
XIM Gen4 LED module
Xicato
®
control panel pc tool
Sylsmart
®
Standalone
SylSmart
®
smartphone app
QR code scan
1. Scan the QR code located on the rear lower label of the double key dimmer switch, Bluetooth
®
2. Configure the dimmer switch via the software application from the Bluetooth® receiver
Содержание 72-503
Страница 2: ...2 English 03 Dansk 08 Support Contact 13 ...
Страница 14: ...72 503 14 ...
Страница 15: ...72 503 15 ...
Страница 16: ...72 503 16 PM72 503_longR22043 ...