![background image](http://html1.mh-extra.com/html/niko/10-512/10-512_manual_1689542033.webp)
33
10-512
EN
Read the complete manual before attempting installation and activating the
system.
1. DESCRIPtIoN
The ‘Liberty Plus’ telephone (10-512) of the Niko Access Control range consists of two
modules, a basic module (identical to the ‘Liberty Base’) and an extension module.
The basic module is provided with 4 function keys: 1 key with door open function, 1 with
light switch function, 1 to switch the ring tone on/off and 1 key with a free function. You can
adjust the volume of the ring tone by means of the setting wheel at the bottom of the internal
unit. The extension module is provided with 10 free function keys with name plate.
2. INStaLLatIoN
Check whether the following components are present:
- telephone box with receiver
Which cables are required?
Niko recommends the following:
- JYSTY(-F2) 3 x 2 x 0,8mm
- TVVF (-F2) 3 x 2 x 0,8mm
- TPVF 3 x 2 x 0,6mm (Limits the number of components to be connected. For specifications,
see technical catalogue Niko Access Control).
tip:
Use the same color code for identical terminals (a, b, P…) for all the Niko Access
Control products in one system!
Note:
Not all provided cable pairs are used. As a result, sufficient spare pairs are available if
one pair is damaged or if you wish to switch to videophony!
Installing the internal unit
The internal unit consists of one base
with two fronts: one for the basic module
and one for the extension module.
Detach both fronts of the internal unit
from the base in the same way (fig.1).
1. Insert a small screwdriver with a width
of ±7mm in the small opening in the
internal unit’s base. Exert pressure
until the front comes off.
2. Remove the front from the base at the
bottom.
3. Remove the front from the base at the
top.
fig.1: removing front plates of internal unit
1
2
3