
65
EN
10-364
8 seconds
The transponder must be held in front of
the device within 8 seconds.
hold transponder in front of device
Briefly hold a transponder of your choice in front of the
device once.
master transponder saved
• a positive confirmation tone sounds
• LED flashes green again
G
exceeded time: transponder is denied
• a negative confirmation tone sounds
• LED lights up red during 3 sec.
R
• LED flashes green again
G
By setting another transponder as the master transponder, the previously programmed transponder is overwritten.
8.4.8. Load factory settings
• The master code is reset to the factory setting.
• The master transponder is removed.
• The set transponders are retained.
Start the programming
if not already done
Enter the following key
combination on the infrared remote
control.
•
* 99 # master code # master code #
• Master code = 6 digits
factory settings loaded
• LED lights up green during 3 sec.
G
• a positive confirmation tone sounds
• LED flashes green again
G
wrong code, master code unknown
• a negative confirmation tone sounds
• LED lights up red during 3 sec.
R
• LED flashes green again
G