
EN
62
10-364
and off again
RUN
PROG
Press the RUN/PROG key briefly. The green LED will light up.
Authorisation via
infrared remote control
Enter the master code.
* Master code #
(FI = <6-digit serial number of the transponder reader>)
With each push on the key, the device
sounds a short key confirmation tone.
correct code:
programming possible
• a positive confirmation tone sounds
• LED lights up green during 3 sec.
G
• LED flashes green
G
wrong code, master code unknown
If you press #, a negative confirmation tone sounds.
After 3 wrong codes, the code entering
function will be blocked for 2 minutes.
• LED lights up red during 3 sec., after flashes green again
R
no code entered
• LED lights up red during 2 min, after flashes green again
Start again.
After 2 min, the devices automatically
terminates the programming mode. The
LED will also switch off.
G
8.4.2. Programming transponder
Start the programming
if not already done
Enter the following key
combination on the infrared remote
control.
* 0 # MlNo #
MlNo = number of the memory location
0 to 49
hold transponder in front of device
Hold the transponder to be programmed in front of the device.
• LED lights up green during 3 sec.
• a positive confirmation tone sounds, LED flashes green again.
• the transponder has been programmed
G
program other transponders
Repeat the steps.
G
only 1 memory location available
• LED flashes orange
O
all 50 memory locations have been
assigned
• LED lights up orange
O