Niko 10-361, Информация о продукте

Страница: 29 / 40

29 EN
10-361
11. MOUNTING AND CONNECTION OF TWO-WIRE VIDEO TRANSMITTER
11.1. Overall picture of the device
10-498
Tw
o-wir
e video transmitter
V
V2 V1 M P b a
12V
Camera Video IN
Video
OUT
1 2
5 4
3
1
Connection terminals camera power supply
2
Connection terminals video input (coax)
3
Control button for brightness
4
Connection terminals video
5
Connection terminals bus
Attention!
The video transmitter is equipped with thermal protection. It switches off the output voltage in case of high load.
Pay attention to the climatic conditions. Ensure proper ventilation.
The device will cause the device to switch off. Take the appropriate steps to prevent water from seeping into the device.
11.2. Connection of two-wire video transmitter
Connecting wires
Connection terminals Wire cross-section Diameter of wires
Video and bus 0,07 - 1,5 mm
2
0,3 - 1,4 mm
Video input (coax) 0,07 - 2,0 mm
2
0,3 - 1,6 mm
Max. number of wires per terminal contact: 2 x 0.8 mm, 3 x 0.6 mm.
• Extra conductors can be connected using aid terminals.
• Only use connection wires from the same material and with the same diameter in a terminal contact.
11.3. Preparing and connecting camera cord
To connect a camera device, the cord must be prepared as follows:
▶
Cut off the video connector.
▶
Strip the conductor and the outer conductor.
▶
Twist the outer conductor.
▶
Connect the conductor:
- conductor to terminal
V
- outer conductor on terminal
12. WARNINGS REGARDING INSTALLATION
• The installation should be carried out by a registered installer and in compliance with the statutory regulations.
• This user manual should be presented to the user. It should be included in the electrical installation file, and it should be passed on to any new owners.
Additional copies are available on the Niko website or via the Niko support service.